IBC camlock tank connection DN40 basic module for 2 tanks

We always recommend venting IBC containers! But especially when IBC tanks are stacked and connected by a tank connection set, venting of the container below is advisable.But why do I need a vent for stacked IBC tanks? - We enlighten you!1. If you stack several IBC tanks and connect them with each other, the lid of the IBC below must in any case be sealed water- or air-tight! If this is not the case, as soon as the maximum filling level has been reached, the water will leak through the lid at the top of the IBC. This case also occurs with vented lids, since water can escape from the vent as well as air.2. If the lid on the IBC container is now closed watertight or airtight, the air is consequently held in the IBC inner container and a counterpressure is formed to the inflowing water. When the two stacked IBC tanks are connected to each other via the valves attached to the tap, the inflowing water prevents the air from escaping from the tank connection.As the process continues, the internal pressure of the air bubble of the lower IBC container becomes at least as great as the water pressure of the inflowing water. Therefore no more water can flow in afterwards and the lower tank can be damaged.The solution: Our tank venting set!You mount a tank feedthrough at the top of the lower IBC container and connect a vent hose to it with the help of a cable tie. You attach the hose to the upper IBC tank (see illustration!). By mounting the venting hose, the air can escape first.If the maximum filling level is now reached in the lower IBC container, the water in the hose starts to rise. Thus, you can fill both IBC tanks to the maximum without any problems.Scope of delivery:1x 2m hose 0,75" (~20mm)1x 90° tank bushing with hose nozzle 0,75" (~20mm), gasket and 0,75" lock nut2x cable tie

With this tank connector set you can add an additional IBC to an already existing connection of two IBC containers. Thus, the prerequisite for this set is the basic module for 2 tanks (item no.: YP0175). This allows you to even triple your storage quantity. The connection to the IBC outlet valve is made via the male coupling with coarse thread S60x6. You do not need any additional sealant for the connection.Scope of delivery:1x Camlock male coupling1x Camlock female coupling1x T-piece DN50-DN25 stepped1x 1m hose DN254x Hose clampsDelivery is WITHOUT the pictured IBC containers.

If you have already connected two IBC containers and want to connect an additional IBC, this tank connector set is the perfect solution! As already mentioned, the prerequisite is the basic module for connecting 2 tanks (item no. YP0191). By connecting around another IBC tank, you will get an even larger storage capacity. The hose size is 1.5" / DN40. Male coupling with S60x6 coarse thread for connection to the IBC valve. Scope of delivery:1x Camlock male coupling1x Camlock female coupling1x T-piece DN50-DN25 stepped1x 1m hose DN404x hose clampsDelivery WITHOUT pictured IBCs.

Our hose clamps are available in sets of 5, are made of galvanized steel (type W1). For a good stability and tightness when connecting, for example, a smooth-walled hose with a hose nozzle / hose adapter provides the hose clamp. The clamping range is between 25-40mm / 0.98-1.57". When tightening the clamp, the inner diameter becomes smaller and thus the hose is sealed with the respective hose adapter. The bandwidth is 9mm / 0.35".

Our T-piece stepped is best suited for the connection of two IBC containers. Thanks to the steps, you can put the hose over in your desired size and then fasten it with a hose clamp. To do this, you only need to shorten the T-piece with a saw, for example. The T-piece is suitable for hose sizes DN50-40-32-25mm..